Had this in mind b4 getting the 390 ... so finally the Powerparts Headlamp arrived somewhere January and the late night oils begin burning ...
things to have
1. Powerparts slim HeadLamp kit
2. Vehicle 7cm Projector Lamp (prolly fitted with H3 halogen bulb)
3. Red LEDs for the Demon Eye
4. Lots of bullet crimp pins
5. 18AWG of cables
6. 2W Resistor , Ohmic value depends of parallel or series combi for Demon eye
7. Relay for Headlamp
8. Tonne of patience
sorry for not posting a video or step by step pictorial guide due to ...
i'm merely experimenting it and i can't figure it out how to make a guide since
i spoilt the 1st unit of the headlamp reflector (melted) and burn 1 of
the Angel Eye and a few more stuff gone bad ...
but anyway, it's possible and here's the end result
LED CREE bulb/lamp - my final choice as it runs cool ... but don't expect
brightness, basically it is 50% less bright then stock ... i mounted my MTB
Headlamp on the handlebar as a backup.
i pull a new powerline for the headlamp fitted with 20A fuse as initial bulb
i use was a 55w, not bright so i change to a PIAA 110w... very bright and
i runs new wires as i'm afraid the stok harness will get warm and prolly
melt, anyway ... both 55w and 110w melted the reflector as the projector
casing is touching the reflector (plastic)
the glare ...
not the best pics, but pics was send to me by a friend, taken from some FB
as my bike was a showbike for the KTM Roadshow event help last 26th January ..