KTM Duke 390 Forum banner
starting issues

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. KTM Duke General Discussion
    I have KTM Duke 390 Bs6 My Version:1V08 Problems with my Bike: 1. My bike is not starting in a single start. 2. Bike wobbles while doing 120+. 3. Ther is a huge powerlag (compred to Bs4 ). Do u guys know any solution? Please ping me...........!
  2. Issues and Troubleshooting
    I went to go for a ride with my mate and the bike started and ran fine but when I pulled over and stopped the engine for a second to check my phone, when I went to turn it back on the ignition switch did nothing! So sound, not even an attempt, tried push starting it but it still won't crank...
  3. Issues and Troubleshooting
    Hi everyone the other day i was riding my Duke 390 2018 on the highway travelling at about 100km/h when bike suddenly made a loud noise and shut off i pulled to the side of the road and the bike would not start, had to tow it home, When i try to start the bike the starter relay makes an...
  4. Issues and Troubleshooting
    Hi guys, Hope you can help. I was riding yesterday and the bike completely cut out and traffic lights and would not start again, red message appeared on dash saying ECU failure. Managed to push the bike home and noticed that the fuel pump does not prime either. I have already disconnected the...
  5. Issues and Troubleshooting
    Hello guys, I am new to this forum and wanted to look for some advice on a starting issue I have had with my KTM Duke 390 to point me in the right direction, it is a 2018 model. For a while, every time I try and start the bike, the starter motor seems to be lazy and doesn't spin over enough, it...
  6. Engine and Technical Discussion
    I am having the kickstand sensor issue on my 2020 Duke. Since I have no actual KTM dealers around I am thinking about just taking the sensor wires and stripping them to put behind the magnet (ie. making the sensor closer). Should I try this or just shell out for a new kickstand assembly. If the...
  7. Issues and Troubleshooting
    Hi have a 2014 Duke 390 The bike has been cutting out after about 10 minutes of running time (either idling or riding) with a solid engine warning light displayed on the dash and won't start until the bike has cooled down (usually about 30-40 mins). I've already checked the entire cooling...
1-7 of 7 Results
Top